Special Cars

1. Add the oil-based dye, supplied in the kit, to the power steering reservoir. The reservoir for the Audi A4 is located on the drivers side inner fender well, just in front of the windshield reservoir. Test-drive the vehicle for 10 minutes to circulate the dye and load the power steering system. This will force small leaks to show up. 2. Use the black light, supplied in the kit, to search under the hood for leaks. Start at the power steering reservoir, following both the small return hose and the larger supply hose to the power steering pump and the rack and pinion steering gear. Note any leaks found. 3. Raise and support the vehicle using the floor jack and jack stands. Then, from underneath, inspect the power steering rack and the power steering hoses. Note any leaks found.

PARTS LIST : 1 Wiring harness w/ 15A fuse, 1 Mounting coupler w/ socket, Ty-wrap(s). QUICK INSTRUCTIONS : STEP.1 Remove the seat & battery cover. STEP.2 Route wires starting at the battery end and finishing at the bracket. STEP.3 Fasten ty-wraps. STEP.4 Connect the red & black wires to the socket. Silicone in the coupler. INSTALLATION INSTRUCTIONS : STEP:1 Remove the seat & side fairing to expose the battery. See the owners manual. STEP:2 Remove negative battery lead. Remove the positive battery lead. Slide the red cover off of the battery post. Slide the cover back over both the stock wire and the fork terminal and attach the red wire. Reattach the battery negative lead. Run the wires down through the gap below the frame rails toward the front of the bike. Follow the very large wiring harness from under the seat toward he front of the bike. STEP:3 Do NOT allow the harness to directly contact the motor or exhaust. Continue routing the harness between the frame ...